5.1.14.15M : Mirror Control
The scanner contains circuitry which allows a scanned document to be flipped over electronically to produce a mirror image. This command allows you to enable or disable the mirror.
When you press <M>, a message will appear indicating the current state of the mirror :
“ MIRROR IS CURRENTLY OFF “ or
“ MIRROR IS CURRENTLY ON “
Next , the following appears :
“ 0 : MIRROR OFF 1 : MIRROR ON CHOICE : “
Press 0 or 1 to set the mirror state ( no <CR> is required ).
Press <CR> to exit without setting the mirror state. The state will remain the same as reported above.
5.1.14.16 T : Test Pattern Control
The video motherboard contains a test pattern generator whose output can be used in place of the image data produced by the cameras. This command allows you to select between these two data sources.
When you press <T>, a message will appear indicating the current source:
“TEST PATTERN IS CURRENTLY ON ” or
“TEST PATTERN IS CURRENTLY OFF ”
Next , the following prompt appears :
“ 0 : TEST PATTERN OFF 1 : TEST PATTERN ON | CHOICE : “ |
Press 0 or 1 to set the source ( no <CR> is required ).
Press <CR> to exit without setting the source. It will remain the same as reported above.