IBM CF Series manual Set Global Parameters, Global Parameters Menu

5.1.1Set Global Parameters (1)

The Global Paramerters affect all scanner operations and will affect your entries in other menus.

When you press <1> for “Set Global Parameters,” a menu display similar to that in Figure 5-9 appears. The values shown in this example are typical for a CF Series 1000 scanner.

----- SET GLOBAL PARAMETERS -----

0		MAXIMUM RESOLUTION		1000
1		NUMBER OF CAMERAS		8
2		SPLICE ON/OFF		On
3		PIXEL SOURCE		Cameras
4	NUMBER OF RESOLUTIONS			8
5		GRAY SCALE ON/OFF		Off
6	NUMBER OF DOCUMENT SIZES			5
7		CCB WINDOW START		0258
8		DISPLAY SYSTEM		In
9			MIRROR	Off
A		DEFAULT ZOOM STATE		Zoomed In
B		AUDIO LEVEL		F
S : SET		X : EXIT	CHOICE: X
			Ready

Figure 5-9 Global Parameters Menu

If you do not want to change anything, press <X> to exit and return to the Diagnostic Tests Menu.

If you press <S> for “Set,” the prompt, “Parameter Number,” will appear. Enter the number for the parameter you wish to change and a prompt will appear, allowing you to change its value.

<0> MAXIMUM RESOLUTION: In the example, the scanner has a maximum resolution of 500 dpi. (do not alter this parameter)

<1> NUMBER OF CAMERAS: In the example shown, four cameras are installed. (do not alter this parameter)

<2> SPLICE ON/OFF: This switch controls the electronic line splice adjustment function of the CALS Board. When the scanner is received from the factory, this function is