Cisco EtherSwitch Service Modules Feature Guide
Information About the Cisco EtherSwitch Service Modules
Table 1 | Basic Comparison of Switch Stacks and Switch Clusters (continued) | |
|
|
|
Switch Stack |
| Switch Cluster |
|
| |
A switch stack can be a cluster command switch or a cluster | A switch cluster cannot be a stack master or stack member. | |
member switch. |
|
|
|
| |
The stack master is the single point of complete management | The cluster command switch is the single point of some | |
for all stack members in a particular switch stack. | management for all cluster members in a particular switch | |
|
| cluster. |
|
| |
The backup stack master is automatically determined in case | The standby cluster command switch must be preassigned in | |
the stack master fails. | case the cluster command switch fails. | |
|
| |
A switch stack supports up to 8 simultaneous stack master | A switch cluster supports only 1 cluster command switch | |
failures. |
| failure at a time. |
|
| |
Stack members (as a switch stack) behave and are presented | Cluster members are various, independent switches that are | |
as a single, unified system in the network. | not managed as and do not behave as a unified system. | |
|
| |
Management of stack members is integrated through a single | Cluster members have separate, individual configuration files. | |
configuration file. |
| |
|
| |
Stack- and | Cluster configuration are stored on the cluster command | |
stack member. |
| switch and the standby cluster command switch. |
|
| |
New stack members are automatically added to the switch | New cluster members must be manually added to the switch | |
stack. |
| cluster. |
|
|
|
Recall that stack members work together to behave as a unified system (as a single switch stack) in the network and are presented to the network as such by Layer 2 and Layer 3 protocols. Therefore, the switch cluster recognizes switch stacks, not individual stack members, as eligible cluster members. Individual stack members cannot join a switch cluster or participate as separate cluster members. Because a switch cluster must have 1 cluster command switch and can have up to 15 cluster members, a cluster can potentially have up to 16 switch stacks, totalling 144 devices.
Cluster configuration of switch stacks is through the stack master.
Note From Network Assistant or the CLI, you can configure a switch cluster to contain up to 16 switch stacks. However, from Network Assistant, the maximum number of actual devices in a switch cluster is 16, irrespective of the number of devices in switch stack cluster members. For example, if a switch stack contains three stack members, they are counted as three separate devices.
If you used the CLI to configure a switch cluster that contains more than 16 actual devices and then try to display the cluster from Network Assistant. Network Assistant requires you to remove cluster members until the Network Assistant limit of 16 is reached.
These are considerations to keep in mind when you have switch stacks in switch clusters:
•If the cluster command switch is not a Cisco EtherSwitch service module or switch stack and a new stack master is elected in a cluster member switch stack, the switch stack loses its connectivity to the switch cluster if there are no redundant connections between the switch stack and the cluster command switch. You must add the switch stack to the switch cluster.
Cisco IOS Release 12.2(25)SEC
32