Cisco Systems NME-16ES-1G Command or Action Purpose, Example, Dir flash, Boot flash image-name

Cisco EtherSwitch Service Modules Feature Guide

How to Configure the Cisco EtherSwitch Service Module

Configuring the Cisco EtherSwitch Service Module in the Router

This section describes how to perform the initial configuration on the router with a Cisco EtherSwitch service module installed. This section also describes the initial configuration on the Cisco EtherSwitch service module itself. Once an IP address has been configured on the Gigabit Ethernet interface on the router (representing the Cisco EtherSwitch service module), you can open a console session to the Cisco EtherSwitch service module and configure its Fast Ethernet and Gigabit Ethernet interfaces for Layer 2 or Layer 3 functionality.

Once the Cisco EtherSwitch service module interface has been configured and you boot up the service module image, you can switch back and forth between the router and the service module.

SUMMARY STEPS

1.dir flash:

2.boot flash: image-name

3.enable

4.show running configuration

5.configure terminal

6.interface slot/port

7.ip address ip address/subnet mask

8.no shutdown

9.end

10.service-module interface slot/port session

11.dir flash:

12.boot flash: image

13.enable

14.show ip interface brief

15.control+shift+6 x

16.disconnect

17.show power inline

DETAILED STEPS

	Command or Action	Purpose
Step 1
	dir flash:	Displays a list of all files and directories in router flash
		memory.
	Example:
	rommon> dir flash:
Step 2
	boot flash: image-name	Boots the router image that supports the Cisco
		EtherSwitch service module.
	Example:	• Enter no when prompted to enter the initial
	rommon> boot flash: c3825-i5-mz.050404	configuration dialog and then press Enter.

Cisco IOS Release 12.2(25)SEC

36