Cisco Systems NME-16ES-1G manual Verifying Information About the Switch Stack, Switch show switch

Cisco EtherSwitch Service Modules Feature Guide

How to Configure the Cisco EtherSwitch Service Module in a Switch Stack

Examples

This section provides the following examples:

•Sample Output for the switch priority Command, page 55

•Sample Output for the show switch Command, page 55

Sample Output for the switch priority Command

The following example shows what appears when you enter the switch stack-member-numberpriority priority-numbercommand:

Switch(config)# switch 2 priority 15

Changing the Switch Priority of Switch Number 2 to 15

Do you want to continue?[confirm]

New Priority has been set successfully

Sample Output for the show switch Command

The following example shows what appears when you enter the show switch command:

Switch> show switch 6

Current

Switch# Role Mac Address Priority State

--------------------------------------------------------

6 Slave 0003.e31a.1e00 1 Ready

Verifying Information About the Switch Stack

To verify the configuration changes that you save after you reset a specific stack member or the switch stack configuration, use the show platform stack-manager all command.

For verification, Step 1 is useful for displaying all switch stack information. Step 2 is useful if you display information about a specific stack member, neighbors, or switch stack ports.

SUMMARY STEPS

1.show platform stack-manager {all counters trace [sdp [reverse] state [reverse]]} [{begin exclude include} expression]

2.show switch

These show switch commands display more detailed switch stack information:

•show switch detail

•show switch neighbors

•show switch stack-ports

Cisco IOS Release 12.2(25)SEC

55