Cisco Systems NME-16ES-1G Enable, Show running configuration, Configure terminal, No shutdown

Cisco EtherSwitch Service Modules Feature Guide

How to Configure the Cisco EtherSwitch Service Module

	Command or Action	Purpose
Step 3
	enable	Enters privileged EXEC mode.
	Example:
	Router# enable
Step 4
	show running configuration	Displays the running configuration of the router, which
		should have a Gigabit Ethernet interface representing the
	Example:	Cisco EtherSwitch service module.
	Router# show running config interface
	gigabitethernet1/0
Step 5
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 6
	interface slot/port	Enters interface configuration mode, and specifies an
		interface for configuration.
	Example:
	Router(config)# interface gigabitethernet1/0
Step 7
	ip address ip address/subnet mask	Configures an IP address and subnet mask on this Gigabit
		Ethernet interface.
	Example:
	Router(config-if)# ip address 20.0.0.1
	255.255.255.0
Step 8
	no shutdown	Enables the service module port.
	Example:
	Router(config-if)# no shutdown
Step 9
	end	Returns you to privileged EXEC mode.
	Example:
	Router(config-if)# end
Step 10
	service-module interface slot/port session	Connects to and opens a session on the Cisco
		EtherSwitch service module.
	Example:
	Router# service-module gigabitethernet1/0 session
Step 11
	dir flash:	Displays a list of all files and directories in flash memory
		on the service module.
	Example:
	Switch: dir flash:
Step 12
	boot flash: image	Boots the Cisco EtherSwitch service module image.
	Example:
	Switch: boot
	flash:c3750-ipservices-mz.122-0.0.13.EZ

Cisco IOS Release 12.2(25)SEC

37