Cisco Systems NME-16ES-1G manual Sample Output for the ping tftpserver Command

Cisco EtherSwitch Service Modules Feature Guide

Upgrading the Cisco EtherSwitch Service Module Software

	Command or Action	Purpose
Step 8
	show run interface fastethernet	Shows the configuration applied on this interface.
	switch/slot/port
	Example:
	Switch# show run interface fastEthernet 1/0/24
Step 9
	ping tftpserver	Pings the TFTP server. This command copies an image from
		a TFTP server to flash memory.
	Example:
	Switch# ping tftpserver
Step 10
	show flash:	Displays a list of all files and directories in the Cisco
		EtherSwitch service module flash memory.
	Example:
	Switch# show flash:
Step 11
	copy tftp: flash:	Copies an image from a TFTP server to flash memory.
	Example:
	Switch# copy tftp: flash:

Examples

This section provides the following examples:

•Sample Output for the show run interface fastethernet Command, page 65

•Sample Output for the ping tftpserver Command, page 65

•Sample Output for the show flash: Command, page 66

•Sample Output for the copy tftp: flash: Command, page 66

Sample Output for the show run interface fastethernet Command

The following example shows what appears when you enter the show run interface fastEthernet command:

Switch# show run interface fa1/0/24 Building configuration...

Current configuration : 87 bytes

!

interface FastEthernet1/0/24 no switchport

ip address 172.16.1.100 255.255.255.0 end

Sample Output for the ping tftpserver Command

The following example shows what appears when you enter the ping tftpserver command:

Switch# ping tftpserver

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 172.16.1.100, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/9 ms

Copy the image from the tftp server to the switch flash using standard tftp copy procedure.

Cisco IOS Release 12.2(25)SEC

65