Cisco Systems NME-16ES-1G manual No switchport, No shutdown

Cisco EtherSwitch Service Modules Feature Guide

Upgrading the Cisco EtherSwitch Service Module Software

SUMMARY STEPS

1.enable

2.configure terminal

3.interface switch/slot/port

4.no switchport

5.ip address ip address/subnet mask

6.no shutdown

7.end

8.show flash

9.copy tftp: flash:

DETAILED STEPS

	Command or Action		Purpose
Step 1
	enable		Enters privileged EXEC mode.
	Example:
	Switch> enable
Step 2
	configure terminal		Enters global configuration mode.
	Example:
	Switch# configure terminal
Step 3
	interface switch/slot/port		Enter interface configuration mode and places you at the
			Fast Ethernet 1/0/24 interface.
	Example:
	Switch(config)# interface fastethernet 1/0/24
Step 4
	no switchport		Enables the routed port.
	Example:
	Switch(config-if)# no switchport
Step 5
	ip address ip address/subnet mask		Sets a primary or secondary IP address for this interface.
	Example:
	Switch(config-if)# ip address 172.16.1.100
	255.255.255.0
Step 6
	no shutdown		Enables the port that is connected to the TFTP server.
	Example:
	Switch(config-if)# no shutdown
Step 7
	end		Exits interface configuration mode, and returns to
			privileged EXEC mode.
	Example:
	Switch(config)# end
	Switch#
		Cisco IOS Release 12.2(25)SEC

64