Cisco Systems NME-16ES-1G manual Sample Output for the switch renumber Command, Show switch

Cisco EtherSwitch Service Modules Feature Guide

How to Configure the Cisco EtherSwitch Service Module in a Switch Stack

	Command or Action	Purpose
Step 4
	reload slot stack-member-number	Resets the stack member, and applies the configuration
		change.
	Example:
	Switch# reload slot 2
Step 5
	show switch	Displays information about the switch stack and its stack
		members.
	Example:
	Switch# show switch

Examples

This section provides the following examples:

•Sample Output for the switch renumber Command, page 53

•Sample Output for the reload slot Command, page 53

•Sample Output for the show switch Command, page 54

Sample Output for the switch renumber Command

The following example shows what appears when you enter the switch current-stack-member-numberrenumber new-stack-member-numbercommand:

Switch(config)# switch 6 renumber 7

WARNING:Changing the switch number may result in a configuration change for that switch. The interface configuration associated with the old switch number will remain as a provisioned configuration.

Do you want to continue?[confirm]...

If another stack member is already using the member number that you just specified, the stack master assigns the lowest available number when you reload the stack member.

Note If you change the number of a stack member, and no configuration is associated with the new stack member number, that stack member loses its current configuration and resets itself to its default configuration.

Caution Do not use the switch current-stack-member-number renumber new-stack-member-number command on a provisioned switch. If you do, the command is rejected.

Sample Output for the reload slot Command

The following example shows what appears when you enter the reload slot command:

Switch(config)# reload slot 6

Proceed with reload? [confirm]y

Cisco IOS Release 12.2(25)SEC

53