Cisco Systems NME-16ES-1G manual Sample Output for Entering an Interface Name

Cisco EtherSwitch Service Modules Feature Guide

How to Configure the Cisco EtherSwitch Service Module

Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system.

Would you like to enter basic management setup? [yes/no]: yes

Sample Output for Entering an Interface Name

The following example shows what appears when you enter an interface name:

Enter interface name used to connect to the

management network from the above interface summary: vlan1

Sample Output for Assigning the IP Address and Subnet Mask

The following example shows what appears when you configure the Cisco EtherSwitch service module IP address and subnet mask:

Configuring interface vlan1:

Configure IP on this interface? [yes]: yes

IP address for this interface: 10.4.120.106

Subnet mask for this interface [255.0.0.0]: 255.0.0.0

Sample Output for Configuring the Cisco EtherSwitch Service Module as a Standalone Service Module

The following example shows what appears when you configure the Cisco EtherSwitch service module to run as a standalone service module:

Would you like to enable as a cluster command switch? [yes/no]: no

You have now completed the initial configuration of the Cisco EtherSwitch service module, which displays its initial configuration. This is an example of output that appears:

The following configuration command script was created: hostname Switch1

enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1 enable password enable_password

line vty 0 15

password terminal-password no snmp-server

!

no ip routing

!

interface Vlan1 no shutdown

ip address 10.4.120.106 255.0.0.0

!

interface FastEthernet1/0/1

!

interface FastEthernet1/0/2

interface FastEthernet1/0/3

!

...<output abbreviated>

!

interface GigabitEthernet2/0/28

!

end

Cisco IOS Release 12.2(25)SEC

47