Cisco Systems NME-16ES-1G manual Current-stack-member-number Renumber new-stack-member-number

Cisco EtherSwitch Service Modules Feature Guide

Switch Stack Configuration Scenarios

Table 4	Switch Stack Configuration Scenarios (continued)
Scenario		Action	Result
Stack master election		Assuming that all stack members have the	The stack member with the cryptographic IP base
specifically determined		same priority value:	image is elected stack master.
by the cryptographic IP		1. Make sure that one stack member has
base image
		the cryptographic IP base image
		installed and that the other stack
		member has the noncryptographic IP
		base image installed.
		2. Restart both stack members at the same
		time.
Stack master election		Assuming that both stack members have the	The stack member with the lower MAC address is
specifically determined		same priority value, configuration file, and	elected stack master.
by the MAC address		software image, restart both stack members
		at the same time.
Stack member number		Assuming that one stack member has a	The stack member with the higher priority value
conflict		higher priority value than the other stack	retains its stack member number. The other stack
		member:	member has a new stack member number.
		1. Ensure that both stack members have
		the same stack member number. If
		necessary, use the switch
		current-stack-member-number
		renumber new-stack-member-number
		global configuration command.
		2. Restart both stack members at the same
		time.
Addition of a stack		1. Power down the new Cisco	The stack master is retained. The new Cisco
member		EtherSwitch service module.	EtherSwitch service module is added to the switch
		2. Through their StackWise ports, connect	stack.
		the new Cisco EtherSwitch service
		module to a powered-up switch stack.
		3. Power up the new Cisco EtherSwitch
		service module.

Cisco IOS Release 12.2(25)SEC

80