XP SBC HC
Installation | Audio Connections |
Notes:
Completely flat batteries need approximately 16 hours to recharge.
The FM headphone will switch off automatically during recharging.
Always remove the batteries if the headphone is not to be used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
Headphone battery replacement (figure 3)
IMPORTANT
Use only rechargeable LR03/AAA NiMH batteries (preferably Philips).
Do not use NiCd batteries or alkaline batteries as these may damage your FM wireless system!
1Remove the earcushions.
2Take out the batteries and dispose of them properly.
3Insert new batteries. Only use LR03/AAA NiMH batteries (preferably Philips).
4Make sure the batteries are correctly inserted as indicated by the engraved symbols in the battery compartment.
5Put the earcushions back on the earshells.
IMPORTANT
Before using the FM headphone for the first time, please ensure that the batteries are fully charged for about 16 hours.This will guarantee a longer operating lifetime of the batteries.
Audio Connections
IMPORTANT
Use only 1 of the audio inputs:
3.5mm stereo headphone audio input OR the line audio input!
Using both audio inputs at the same time may damage your FM wireless system or your audio source!
Option 1 (figure 4)
Connecting the FM transmitter to a line output of an audio source, e.g. REC OUT,
LINE OUT.
1Connect the 3.5mm stereo plug of the stereo audio cable to the FM transmitter’s 3.5mm headphone input.
2Connect the 2 RCA plugs of the stereo audio cable to a line output (REC OUT or LINE OUT) of an audio source, e.g.TV, HiFi or PC:
–Check if the red RCA plug (right channel) is connected to the right channel (red) of the audio source.
–Check if the white RCA plug (left channel) is connected to the left channel (white) of the audio source.
3Switch on your audio source.The red power indication LED of the transmitter lights up if receiving an audio signal.
4In case the line output of the audio source has an adjustable output level, adjust the line output level of the audio source to the highest acceptable undistorted level.
5Switch on the headphone.You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter.
6To tune, press and hold the tuning control button for about 1 second. Repeat if necessary until the red tuning indication lights up.
English
7