Extron electronic PVS 305SA manual Finish Projector Drop Ceiling Mount installation

6.Finish Projector Drop Ceiling Mount installation

a.Detach the projector bracket/projector from the adjuster plate. Do not remove the projector bracket from the projector.

b.Unscrew the UPB 25 adapter plate from the mounting pole.

c.Loosen the set screws on the PCM 340 and the pipe location screw and remove the mounting pole, then loosen the T-frame securing screws and remove the

PCM 340 from its marked location.

d.Replace the cut ceiling tile, checking its orientation to align the hole with the PCM 340.

e.Replace the PCM 340 over the ceiling tile, slide the slotted pipe up through the tile and into the adapter plate. Realign the location holes with the pipe holes, insert and tighten down the location screw. Tighten the set screws.

f.Tighten the four T-frame securing screws on the

PCM 340. The T-frame securing screws can be used on either side of the frame.

6e Slide the pipe through the ceiling tile and into the pipe adapter plate

7.Secure the Projector Drop Ceiling Mount to the ceiling

a.Attach the four turnbuckles to the mounting plate, one at each corner.

CDO NOT rest or lean on the mounting plate or suspended ceiling when attaching turnbuckles, tie wire, or when drilling into the ceiling

NFor safest installation, insert the turnbuckle from the outside so that it hooks inwards.

b.Cut four equal lengths of the supplied hanging wire, and loop the wire through the anchors or lag eye bolts, and the turnbuckles, then twist the wire around itself at least five times tightly at each end.

c.Hand tighten the turnbuckles and level the plate so it just rests on the T-frame.

CThe four hanging wires should be taut, taking the full weight of the completed installation.

Do not overtighten the turnbuckles or the T‑frame assembly could be lifted, making the suspended ceiling bowed and unsafe.

d.Pass the braided safety cable through the fifth and center anchor and attach it to the center holes on either side

of the plate. Ensure the cable is of equal length on both sides of the anchor and secure the cable using the cable clamps.

7a Attach turnbuckles at the corners

Secure PCM to frame (from either side)

PCM

T-frame

Adjust the turnbuckles to take up any slack in the hanging wire.

7c Hand tighten the turnbuckles

PoleVault Systems Installation • Installation — Stage 1 2-6