Extron electronic PVS 305SA manual Optional Accessory Installation VoiceLift System

Optional Accessory Installation — VoiceLift System

The Extron VoiceLift system is an easy-to-use, low-power, voice amplification system that ensures the speaker’s voice

can be clearly heard at a comfortable level throughout the classroom. Speech is picked up by the pendant microphone

worn by the teacher and is transmitted wirelessly via a base station receiver and the PVS 305SA to the installed ceiling

speakers.

For detailed installation information, refer to the VoiceLift Installation Instructions, supplied with the device.

VoiceLift System included parts:

•VLP 102 pendant microphone

•VLR 102 Receiver

•Wall charger

Installation Procedure

WAll structural steps, anchoring, and electrical installation should be performed by qualified personnel in accordance with local and national building codes, fire and safety codes, and local and national electrical codes.

1. Determine the optimal receiver location and mark and drill a 2.5 inch hole in the ceiling tile where it is to be installed.

2. Insert the ceiling bracket screw through the back plate (attached to the housing) and the hole in the ceiling tile and loosely attach the Z bracket.

3.Align the back plate knockout over the hole in the ceiling tile and tighten the bracket screw to secure.

4. Replace the ceiling tile.

5. Pull the communication/power RJ-45 Ethernet cable (and

other secondary use cables) through the receiver’s base

and connect the Ethernet cable to the Receiver OUT port (the RJ-45 connector on the left on the receiver base).

6.If desired, set the Tone and Mix DIP switches on the receiver base.

7.Place the dome onto the housing, align the arrows on the dome’s locking tab and on the housing rim. Turn the dome until it locks in place (approximately 1/8 turn).

8. Pull the cables from the receiver to the PVS 305SA

switcher’s location, through the pipe and down into the PMK 550.

9. Disconnect the power from the switcher, and plug the

included VoiceLift RJ-45 into the PVS 305SA’s VoiceLift

receiver port.

10. Replace power to the switcher. This also powers the

VoiceLift receiver.

2Attach the Z bracket to the ceiling tile and the back plate.

Tab	Arrow
	Dot
	Tab
	Align Arrows
Twist to	Arrow
Lock

Receiver

Dome

7Align the arrows on the housing rim and the dome tab.

		17TT		LINE OUT	AMPLIFIED AUDIO OUT
	® US				DO NOT
		AUDIO/VIDEO			GROUND
	LISTED	APPARATUS			OR SHORT		2/4/8
					SPEAKER		Ohms
	OUTPUTS	VOICELIFT	L	R	OUTPUTS
		RECEIVER			CLASS 2 WIRING	L	R
RGB	VIDEO
			L	R	10V	50mA	CONTROL
							Tx Rx IR 12V
			AUX AUDIO		PAGING		RS-232 MLC/IR
				INPUT 5	SENSOR VOL/MUTE

VoiceLift

input

9Plug VoiceLift cable into PVS 305SA

PoleVault Systems Installation • Optional Accessory Installation 3-1