Extron electronic PVS 305SA manual Install wall plates, MLC 104 IP Plus controller

3.Install wall plates

a.Connect the CAT 5 cables to the rear of the input devices

(for RGB devices, connect cable labeled A to port A and cable B to port B).

b.If desired, for PVT RGB D Plus plates, use a three conductor audio cable and connect the audio return to the connector marked G (ground wire), R (black wire), and L (red wire). The other end will be connected to the

“Line Out” connection on the PVS 305SA switcher.

c.If desired wire the IR connection using a two conductor cable. Wire the ground to G and signal lead to S. The other end will be connected to the “IR Out” port of the

MLC 104 IP Plus controller.

d.Mount each device into the mud ring, using the supplied screws.

e.Attach the supplied Decora faceplate.

f.Label the Decora plate with the supplied label, using the appropriate input number. This makes inputs easier to identify when configuring the switcher.

g.Repeat steps a-ffor other wall plates.

3a Connect the cables to the A/V source input devices at each location.

Wall

Wall Mounting

Bracket (mud ring)

Decora®

Faceplate

AUDIOOUT
IN	IN
COMPUTER
	OUT
MONITOR
S	G
IR OUT

Extron

PVT RGB D Plus

3b Mount the PVT in the mud ring, then 3c attach the Decora faceplate.

PoleVault Systems Installation • Installation — Stage 2 2-12