Quick Installation

1 Connect your computer to the UPS, and the UPS to an electrical outlet.

1.Unplug your computer’s power cord from both your AC outlet and your computer’s AC input.

2.Find the power cord that came with your UPS

(A). Insert the UPS cord’s female plug into your computer’s AC input. Insert the UPS cord’s male plug into any of your UPS’s female output receptacles.

3.Insert the female plug of your computer’s cord

(B)into your UPS’s AC input. Insert the male plug of your computer’s cord into your AC outlet.

2 Plug your monitor and external modem into battery- supported outlets. Plug other equipment into surge-only outlet(s).

Separate battery-supported/surge and surge-only outlet(s) are available only on select models (identified on the back of your UPS). Your UPS is designed to support only computer equipment. You will overload your UPS if you connect household appliances, laser printers or surge suppressors to the battery-supported outlets.

Cords and receptacle adapters are available from Tripp Lite to accommodate most outlet configura- tions. If rewiring is necessary, refer to the Wire Color-Code Chart at the bottom of the page.

SEE MANUAL

3 Set your UPS’s “OFF – ON” Switch.*

USA, Canada & Western Europe

· Set it and leave it “ON” at all times.

All Other Countries

·Set to “OFF” when you are not using connected equipment. (WARNING! When set to “OFF,” UPS will not provide battery backup during a blackout or brownout)

·Set to “ON” when you are using connected equipment.

*See Basic Operation section for the Switch Function, UPS Conditions and Setting Advantages.

BlackBrown

WhiteBlue

AMER EURO

GreenGreen/ Yellow

Wire Color	Wire 1	Wire 2	Wire 3
American	Black	White	Green
European	Brown	Blue	Green/Yellow
Wire Reference	Wire 1	Wire 2	Wire 3
American	Line 1	Neutral	Ground
European	Line 1	Line 2 or Neutral	Ground