Indicator Lights, Other UPS Features | Tripp Lite OMNIPRO manual

Indicator Lights

All Indicator Light descriptions apply when the UPS is plugged into a wall outlet and turned on.

This green light will turn ON whenever your UPS is plugged in and receiving normal AC line power.

	This red light will turn ON when your UPS is providing your equipment
	with battery power.


	This red light will turn ON when the UPS’s capacity has been exceeded

	while it is operating from battery power (either during a self-test or
	during a blackout). Remove overload from battery-supported outlets
Available on	immediately.
select models

	This yellow light will turn ON continuously after you test your UPS

	battery’s charge with the “Mute/Test” Switch to indicate that the UPS’s
	battery is less than fully charged. If it stays on continuously, contact
Available on	Tripp Lite for service. The light will flash after you set the “OFF/ON”

select models	Switch to the “OFF” position to indicate that the UPS will not provide

	battery backup during a blackout or brownout.

	Whenever your UPS is automatically correcting high or low AC line

	voltage, this green light will turn ON and the UPS will gently click. The
	more the UPS has to correct voltage, the more the green light will turn
Available on	ON and the more the UPS will click. These are both normal, automatic
select models	operations of your UPS, and no action is required on your part.

Other UPS Features

AC Receptacles: The receptacles provide your connected equipment with AC line power during normal operation and battery power during blackouts and brownouts. They also protect your equipment against damaging surges and line noise. Select models, however, feature “surge-only” receptacle(s) (identified on the back of the UPS) that provide peripherals with surge protec- tion without committing precious battery power to support them during blackouts.

RJ11 Telephone Jacks (Available on select models): These jacks protect your

equipment against telephone line surges. Connecting your equipment to these jacks is optional. Your UPS will still work properly without this connection.

DB9 Port (Available on select models): The DB9 port connects your UPS to any

workstation or server. Use with Tripp Lite software and cabling to automatically save open files and shut down equipment during a blackout. This port sends contact-closure signals to indicate line-fail and low-battery status. Contact Tripp Lite Customer Support for more information.

Battery Replacement Door: Under normal conditions, the original battery in your UPS will last several years. Battery replacement should be performed only by qualified service personnel. Refer to “Battery Warnings” in the Safety section on page 2.