Schneider Electric AP9635 manual User

Option	Argument	Description
-output	<phase#> all	Display the output measurements for the chosen phase of the UPS.
		Typing “all” displays the information for all phases of the UPS.
	voltage current load	Specify the output measurement for the ups command.
	power percload pf	Example: ups -output 2 percload
	frequency all	Displays the percentage of load for phase 2 of the UPS.
-batt		Display the battery status of the UPS
-about		Displays information about the UPS.
-al	<c w>	Display all existing alarms. Specifying “c” or “w” limits the display to
		either Critical (c) or Warning (w) alarms.

user

Access: Administrator only

Description: Configure the user name and password for each account type, and configure the inactivity timeout.

For information on the permissions granted to each account type (Administrator, Device User, and Read-Only User), see “Types of user accounts” on page 3.

Option	Argument	Description
-an	<admin name>	Set the case-sensitive user name for each account type. The maximum
-dn	<device name>	length is 10 characters.
-rn	<read-only name>
-ap	<admin password>	Set the case-sensitive password for each account type. The maximum
-dp	<device password>	length is 32 characters. Blank passwords (passwords with no
-rp	<read-only password>	characters) are not allowed.
-t	<minutes>	Configure the time (3 minutes by default) that the system waits before
		logging off an inactive user.

Example: To change the Administrator user name to XYZ, type:

user -an XYZ

To change the Administrator password to XYZ, type:

user -ap XYZ

Network Management Card User’s Guide 26