Schneider Electric AP9635 manual Active, Automatic, Direct Notification, Mail notification

Active, Automatic, Direct Notification

E-mail notification

Overview of setup. Use the Simple Mail Transfer Protocol (SMTP) to send e-mail to up to four recipients when an event occurs.

To use the e-mail feature, you must define the following settings:

•The IP addresses of the primary and, optionally, the secondary Domain Name System (DNS) servers

See “DNS” on page 57.

•The IP address or DNS name for SMTP Server and From Address

See “SMTP” on page 67.

•The e-mail addresses for a maximum of four recipients

See “E-mail recipients” on page 68.

Note: You can use the To Address setting of the recipients option to send e-mail to a text-based pager.

SMTP.

Path: Administration > Notification > E-mail > server

Setting	Description
Local	The IP address or DNS name of the local SMTP server.
SMTP	NOTE: This definition is required only when SMTP Server is set to Local. See “E-mail
Server
	recipients” on page 68.
From	The contents of the From field in e-mail messages sent by the Management Card:
Address	• In the format user@ [IP_address] (if an IP address is specified as Local SMTP Server)
	• In the format user@domain (if DNS is configured and the DNS name is specified as Local
	SMTP Server) in the e-mail messages.
	NOTE: The local SMTP server may require that you use a valid user account on the server for
	this setting. See the server’s documentation.

67 Network Management Card User’s Guide