Ampro Corporation 700 manual # of Floppy Drives Bios Settings, Boot Order

Chapter 4			BIOS Setup
Table 4-2. Floppy Drive BIOS Settings
	# of Floppy Drive(s)		BIOS Settings
	None		• Set Drives A and B to [None]
	(1)	Non-USB Floppy*	• Configure Drive A to floppy drive type (For example, [1.44MB, 3.5”] )
			• Set Drive B to [None]
	(1)	USB Floppy	• Set USB Boot Support to [Enable]
			• Set Drive A to [USB Floppy]
			• Set Drive B to [None]
	(2)	Floppy drives	• Set USB Boot Support to [Enable]
	(1 USB Floppy and 1		• Configure one drive (Drive A or B) to floppy drive type
	non-USB Floppy drive*)		(For example, [1.44MB, 3.5”] )
			• Set one drive (Drive B or A) to [USB Floppy]

Table Note: *A standard 34-pin floppy cable has a twist in the cable wiring between the Floppy A and B connectors, where Floppy B has the straight through cable (non-twist) and is the middle connector. Due to the ReadyBoard 700’s internal configuration and the cable supplied, there is only one physical connector available (the Floppy B connector, because the Floppy A connector is not available).

NOTE	Ampro does not recommend connecting a USB boot device to the
	ReadyBoard 700 through an external hub. Instead, connect the USB
	boot device directly to the ReadyBoard 700.
	Any USB (block) device that emulates a hard disk drive can be used
	when [USB HDD] is set as the drive option. This includes various
	storage media types, such as USB hard disk drives, USB CD-ROMs,
	CompactFlash cards, and Flash or Thumb drives. Refer also to
	Boot Order settings, USB Boot Support under Advanced features,
	and USB (device enable) under On-Board Controllers for USB Drive
	boot order, USB Boot Enable, and the number of USB ports enabled,
	respectively.

♦Drive E – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave], [CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master], [HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]

♦Drive F – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave], [CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master], [HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]

♦Drive G – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave], [CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master], [HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]

•Boot Order

♦Boot 1st – [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]

♦Boot 2nd – [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]

NOTE	The [Alarm] option sounds beeps on the PC speaker and can be
	listed, like [Reboot], as the last boot device to indicate no bootable
	device was not found.
	Any of the drives can be listed as a boot drive.

ReadyBoard 700 Reference Manual 59