MicroNet Technology SP5001/S Additional Installation Requirements, Setting Up the TCP/IP Protocol

Step 5. Grounding SP5001/S

If you want to ground SP5001/S then connect a grounded wire to the F.G. (Frame Ground) of SP5001/S.

1.6Additional Installation Requirements

In addition to the contents of your package, there are other hardware and software requirements you need before you can install and use your SP5001/S. These requirements include:

1.A computer with an Ethernet NIC (Network Interface Card) installed.

2.A computer equipped with communications software configured to the following parameters:

ŸVT100 terminal emulation.

Ÿ9600 Baud.

ŸNo parity, 8 Data bits, 1 stop bit, Flow Control set to None.

3.Use Internet Explorer 5.5 and later or Netscape Navigator 6 and later versions.

After SP5001/S is properly set up, you can make future changes to the configuration through telnet connections.

1.7Setting Up the TCP/IP Protocol

If you are not sure whether the TCP/IP Protocol has been installed, follow these setups to check, and if necessary, install TCP/IP onto your PCs.

Step 1. Click the “Start” button, Choose “Settings”, then “Control Panel”.

Double-click the “Network” icon. Your Network window should appear as follows.

Step 2. Select the “Configuration” tab.

Note:

For Windows 2000 & Windows XP Setting, you will find that they differ with Windows 98/ME/NT slightly. See the Following for reference.

Click the “Local Area Connection” icon on the lower right hand side of your desktop screen.

In the “Local Area Connection Status” windows, click the “Properties” button, and then your Network windows will appear.

There is only one tab, “General”, in the Network window.

13