MicroNet Technology SP5001/S user manual Back Panel Port Ethernet Port, COM Port, TEL Port

Page 12

1.5.2Back Panel Port Ethernet Port:

Ethernet port is for connecting SP5001 to network, transmit rate supports 10/100 Base-T.

Ethernet connector LAN

COM Port:

RS232 console port (DB-9pin male connector)

Note: use straightforward cable to connect to your computer.

PINOUTS

PinName Dir Description

2RXD Receive Data

3TXD Transmit Data

5 GND System Ground

TEL Port:

RJ-11 connector, FXS interface. To connect analog phone sets or trunk line of PABX.

11

Image 12

Contents IP Telephony Gateway Table of Contents Voice Setting Screen List of Figures Change password Screen List of Tables About this User’s Manual Features of SP5001/S Key FeaturesAudio feature SP5001/S OverviewDefault Settings Remote Firmware UpgradeTelnet and Web Login Password SecurityFront Panels Back PanelHardware Specifications 1 SP5001/S LEDs SP5001/S LEDs DescriptionsBack Panel Port Ethernet Port COM PortTEL Port 12V DC Port Back Panel ConnectionsAdditional Installation Requirements Setting Up the TCP/IP ProtocolPower Up Your SP5001/S Web Configuration with FXS Introduction Accessing the Web ConfigurationWelcome Screen SP5001/S web configuration welcome screen Navigation Panel LinksSaving Your Configuration Navigating the Web ConfigurationInitial Configuration General ConfigurationStatic IP address Commit Data Dhcp mode IP Sharing Configuration One Sets SP5001/SEnable the IP sharing function Two sets attached to IP Sharing Device Router See following for example Page Configure the gateway into the Peer-to-Peer mode Making a VoIP CallPhone Book On table will display on the first index Configure the gateway into the Proxy routed mode Configure the Proxy InfomationUpgrade ROM Version Update Application VersionBefore you start downloading ROM File Upgrade OK Page H323 Configuration Network Interface ScreenGMT SIP Information Screen SIP InformationSystem Configuration Screen System ConfigurationVoice Setting Screen Voice ConfigurationBecause this might cause incompatibility Phone Pattern Configuration Phone Pattern ScreenSupport Configuration Support Function ScreenPhone Book Screen Label Description Dscp Configuration Screen Dscp ConfigurationPassword Screen PasswordROM Upgrade Screen Flash Clean Screen Commit Data Screen Reboot System Screen Command List Hyper Terminal SettingConnect To Initial Screen Entering Login Initial ScreenCommand Structure in SP5001/S Set PasswordCommand Structure in SP5001/S Set up IP AddressApplication Mode Configuration Saving Your ConfigurationProxy mode Application modesUsr/config$ security -line 1 -name 12345 -password Peer-to-Peer Mode Behind IP-Sharing Mode One Set of SP5001/S DMZ Two Sets of SP5001/S UDP PPPoE Mode How to upgrade Upgrade stepsBefore you start downloading Usr/config$ rom -hwver Commands in SP5001/S Commands in SP5001/SSystem Commands Overview QuitParameter Usages Flash command list FlashCommit command list Ifaddr CommitIfaddr -print command list Time command list Ping TimePhone book command list PbookPhoneBook Rules Pppoe command list PppoeSystem information command list SysconfSysconf -print command list Sip command list 19.7.12 sipSip -print command list Security Command List Voice command list VoiceParameters because this might cause incompatibility Voice -print command list Support Support -print command list 19.7.16 tos Phone command list PhonePhone -print rbt command list Rom command list 19.7.18 romRom -print command list Passwd