MicroNet Technology SP5001/S user manual Phone -print rbt command list

Parameter Usages:
-print	print current call progress tone configurations (ring: ring tone, rbt:
	ring back tone, bt: busy tone, dt: dial tone). This parameter
	should be accompanied with tone type. For example:
usr/config$ phone -print rbt
Phone ringback tone parameter
Ringback Tone frequency high		: 480
Ringback Tone frequency low		: 440
Ringback Tone frequency high level : 155
Ringback Tone frequency low level		: 155
Ringback Tone tone1 on		: 2000
Ringback Tone tone1 off		: 4000
Ringback Tone tone2 on		: 2000
Ringback Tone tone2 off		: 4000
usr/config$

Figure 65. phone –print rbt command list

Note:

For tone simulation, SP5001/S adopts d ual frequencies as traditional telephone does. If users want to have their own call progress tone, they can change the value of tones. High and Low frequency/level/cadence can be configured respectively.

-ring	to set RING tone value.
	The played tone type, when SP5001/S is receiving a call.
-rbt	to set RingBackTone value
	The played tone type, when SP5001/S receives a Q.931
	Alerting message. In condition that SP5001/S is the originating
	side.
-bt	to set BusyTone value.
	The played tone type, when destination is busy.
-dt	to set DialTone value.
	The played tone type, when hook off a phone set of workable
	SP5001/S.
-flash	set the detective flash range in ms, for example, 300-500 ms.

83