MicroNet Technology SP5001/S Initial Configuration, General Configuration, Static IP address

Page 19

3.Initial Configuration

This chapter describes the procedure for the initial configuration of SP5001/S. Refer to the relevant chapters in this User’s Manual for descriptions of the fields and buttons within individual screens.

3.1General Configuration

SP5001/S has a factory default IP address of 10.1.1.3 and a subnet mask of 255.0.0.0.

3.2Static IP address

Step 1. To configure the IP address of SP5001/S, click Network Interface on the navigation panel. In the Network Interface screen, type a new IP address, subnet mask and the default routing gateway (e.g. IP Address: 192.168.4.71, Subnet mask: 255.255.0.0, Default routing gateway: 192.168.1.254) and click the OK button.

Figure 4. Network Interface

Step 2. Click Commit Data on the navigation panel. In the Commit Configuration Data screen, click the Commit button. In the Commit Configuration Data screen to Display Commit to Flash OK!, When the Commit Data Ok.

18

Image 19

Contents IP Telephony Gateway Table of Contents Voice Setting Screen List of Figures Change password Screen List of Tables About this User’s Manual SP5001/S Overview Features of SP5001/SKey Features Audio featureSecurity Default SettingsRemote Firmware Upgrade Telnet and Web Login PasswordBack Panel Front Panels1 SP5001/S LEDs SP5001/S LEDs Descriptions Hardware SpecificationsCOM Port Back Panel Port Ethernet PortTEL Port Back Panel Connections 12V DC PortSetting Up the TCP/IP Protocol Additional Installation RequirementsPower Up Your SP5001/S Accessing the Web Configuration Web Configuration with FXS IntroductionWelcome Screen Navigation Panel Links SP5001/S web configuration welcome screenNavigating the Web Configuration Saving Your ConfigurationGeneral Configuration Initial ConfigurationStatic IP address Commit Data Dhcp mode One Sets SP5001/S IP Sharing ConfigurationEnable the IP sharing function Two sets attached to IP Sharing Device Router See following for example Page Making a VoIP Call Configure the gateway into the Peer-to-Peer modePhone Book On table will display on the first index Configure the Proxy Infomation Configure the gateway into the Proxy routed modeUpdate Application Version Upgrade ROM VersionBefore you start downloading ROM File Upgrade OK Page Network Interface Screen H323 ConfigurationGMT SIP Information SIP Information ScreenSystem Configuration System Configuration ScreenVoice Configuration Voice Setting ScreenBecause this might cause incompatibility Phone Pattern Screen Phone Pattern ConfigurationSupport Function Screen Support ConfigurationPhone Book Screen Label Description Dscp Configuration Dscp Configuration ScreenPassword Password ScreenROM Upgrade Screen Flash Clean Screen Commit Data Screen Reboot System Screen Hyper Terminal Setting Command ListConnect To Initial Screen Initial Screen Entering LoginSet up IP Address Command Structure in SP5001/SSet Password Command Structure in SP5001/SApplication modes Application Mode ConfigurationSaving Your Configuration Proxy modeUsr/config$ security -line 1 -name 12345 -password Peer-to-Peer Mode Behind IP-Sharing Mode One Set of SP5001/S DMZ Two Sets of SP5001/S UDP PPPoE Mode Upgrade steps How to upgradeBefore you start downloading Usr/config$ rom -hwver Commands in SP5001/S Commands in SP5001/SQuit System Commands OverviewParameter Usages Flash Flash command listCommit Commit command list IfaddrIfaddr -print command list Time Time command list PingPbook Phone book command listPhoneBook Rules Pppoe Pppoe command listSysconf System information command listSysconf -print command list 19.7.12 sip Sip command listSip -print command list Security Command List Voice Voice command listParameters because this might cause incompatibility Voice -print command list Support Support -print command list 19.7.16 tos Phone Phone command listPhone -print rbt command list 19.7.18 rom Rom command listRom -print command list Passwd