Product Description
8.Remove the runner from which all lag bolts have been removed (refer to Figure 6).
Figure 6 Remove runner from pallet
Slide this runner away
from the Liebert XDP
9.Using the pallet jacks, raise the secured unit to the highest point that the piano jacks will allow. Once the unit has been raised, slide the remainder of the pallet from under the Liebert XDP (see Figure 7). Lower the Liebert XDP so that its base is approximately 1" (25.4mm) off the ground.
Figure 7 Sliding pallet from under Liebert XDP
Slide the remaining part of the pallet from under the Liebert XDP so the unit may be moved on the piano jacks.
1.3.3Removing Piano Jacks
Once the unit has been moved to the installation location, Emerson Network Power recommends the following method to remove the piano jacks:
1.Lower the unit as far as the piano jacks will allow.
2.Undo all strapping holding the piano jacks to the unit.
3.Remove all cushioning material used to protect the unit from the straps and the piano jacks.
4.Use a pry bar or other lever to lift one side of the Liebert XDP enough to allow removal of the piano jack.
5.Repeat Step 4 to remove the piano jack on the opposite side.
6.Remove the plastic bag.
4