Lantronix 900-691-R Tunnel Packing Mode Settings, Tunnel Packing Mode Description Settings

6: Tunnel Settings

Packing Mode

With Packing, data from the serial Line is not sent over the network immediately. Instead, data is queued and sent in segments, when either the timeout or byte threshold is reached. Packing applies to both Accept and Connect Modes.

	Table 6-2 Tunnel Packing Mode Settings
Tunnel Packing Mode		Description
Settings
Mode		Configure the Tunnel Packing Mode. Choices are:
		 Disable = Data not packed.
		 Timeout = data sent after timeout occurs.
		 Send Character = data sent when the Send Character is read on the Serial
		Line.
Timeout		Set the timeout value, in milliseconds, after the first character is received on
		the serial line, before data is sent on the network. Valid range is 1 to 30000
		milliseconds. Default is 1000.
		Note: This configuration option becomes available when Timeout is the
		selected Mode.
Threshold		Set the threshold (byte count). If the received serial data reaches this
		threshold, then the data will be sent on the network. Valid range is 100 to
		1450 bytes. Default is 512.
		Note: This configuration option becomes available when Timeout is the
		selected Mode.
Send Character		Enter Control Characters in any of the following forms:
		 <control>J
		 0xA (hexadecimal)
		 \10 (decimal)
		If used, the Send Character is a single printable character or a control
		character that, when read on the Serial Line, forces the queued data to be
		sent on the network immediately.
		Note: This configuration option becomes available when Send Character is
		the selected Mode.
Trailing Character		Enter Control Characters in any of the following forms:
		 <control>J
		 0xA (hexadecimal)
		 \10 (decimal).
		If used, the Trailing Character is a single printable character or a control
		character that is injected into the outgoing data stream right after the Send
		Character. Disable the Trailing Character by blanking the field (setting it to
		<None>).
		Note: This configuration option becomes available when Send Character is
		the selected Mode.

xPico® Wi-Fi® Embedded Device Server User Guide 35