|
| 6: Tunnel Settings |
|
|
|
| Tunnel Connect | Description |
| Mode Settings |
|
| Block Network | Select to enable or disable the block network, which is used for debugging |
|
| purposes. |
|
| Enabled: incoming characters from the network will not be forwarded to the |
|
| serial line but will be buffered and eventually flow off the network side. |
|
| Disabled: incoming characters from the network are sent on into the serial line. |
|
| Any buffered characters are sent first. This is the “normal” setting. |
|
|
|
To Configure Tunnel Connect Mode Settings
Using Web Manager
To configure the Disconnect Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1
Using CLI
To enter the Tunnel command level: config
Using XML
Include in your file: <configgroup name = "Tunnel Connect" instance = "1">
Disconnect Mode
Specifies the optional conditions for disconnecting any Accept Mode connection that may be established. If any of these conditions are selected but do not occur and the network disconnects from the device, a Connect Mode connection will attempt to reconnect. However, if none of these conditions are selected, a closure from the network is taken as a disconnect.
| Table |
|
|
Tunnel Disconnect | Description |
Mode Settings |
|
Stop Character | Enter the Stop Character which when received on the Serial Line, disconnects the |
| tunnel. The Stop Character may be designated as a single printable character or |
| as a control character. Control characters may be input in any of the following |
| forms: <control>J or 0xA (hexadercimal) or \10 (decimal). Disable the Stop |
| Character by blanking the field to set it to <None>. |
|
|
Modem Control | Select to enable or disable the disconnect when modem control pin is not asserted |
| on the serial line. |
|
|
Timeout | Enter the number of milliseconds a tunnel may be idle before disconnection. The |
| value of zero disables the idle timeout. |
|
|
Flush Line | Set whether to flush the Serial Line when the Tunnel is disconnected. Choices are: |
| Enabled |
| Disabled (default) |
|
|
xPico® | 39 |