Lantronix 900-691-R Monitor Poll Settings, Monitor Filter Settings, Poll Settings Description

11: Monitor

Access the configuration options displayed in Table 11-4on the Poll page. These configuration fields are the same ones in Step 3: Define Filters if utilizing Explorer.

	Table 11-4 Monitor Poll Settings
Poll Settings	Description
Message <Number>	Click the Edit link to edit a specific message; this is where a command is entered.
	Four message fields will open to allow configuration of a specific command. When
Note: In other pages	you begin entering information in these fields, additional Message <Number>
	options become available containing the four message fields which will also open
(Commands/Control	upon clicking Edit. Complete the Message <Number> fields:
and Poll) in Explorer	 Command: enter the command in binary format (printable characters or binary
or under
	string)
Configuration,
	 End Character: indicate as a single printable character or as a control character.
additional Message
	Control characters may be input as <control>J, 0xA (hexadecimal) or \10
<Number> fields will
	(decimal).
become available to
	 Length: set the length of the response.
further filter and
	 Timeout: set the timeout length. Minimum timeout length is 100 milliseconds.
specify the information
you wish to monitor.	Click Submit after making changes to get real time response displayed if you are
	utilizing Explorer.
Delay	Set the initial delay time in milliseconds before the monitor starts processing the
	initialization message. This field appears in Step 1: Setup Initiation.

Access the configuration options displayed in Table 11-5on the Filter page. These configuration fields are the same ones in Step 3: Define Filters if utilizing Explorer.

	Table 11-5 Monitor Filter Settings
Filter Settings	Description
Rule <Number>	Click the Edit link to edit a specific rule. Two rule configuration fields will open for
	this rule. When you begin entering information in these fields, additional Rule
	<Number> options become available containing the two rule configuration fields
	which will also open upon clicking Edit. Complete the Rule <Number> fields:
	 Source: indicate the input of the filter. For example, if the source of this filter is
	the second trunk of data created by filter 1, the source should be set to 1.2. A
	Source of 0 indicates the raw response.
	 Mode: select filter mode (All, Delimiters or Binary)
	 Delimiter <Number> Binary String: Enter the filter breaks input up to 8 trunks
	separated by binary string. Each trunk will not contain the delimiters. This field
	appears when Delimiter Mode is selected.
	 Start index: set to indicate when delimiters filter start breaking input into trunks,
	if the Delimiter Mode is selected.
	 Offset: set the size of the first trunik of data created by the binary filter, if
	selected.
	 Length: set the size of the second trunk of data created by the binary filter, if
	selected. The third trunk of data created by the binary filter will contain the rest of
	the input.

xPico® Wi-Fi® Embedded Device Server User Guide 58