Lantronix 900-691-R manual Services Settings, Http Settings

8:Services Settings

HTTP Settings

Hypertext Transfer Protocol (HTTP) is the transport protocol for communicating hypertext documents on the Internet. HTTP defines how messages are formatted and transmitted. It also defines the actions web servers and browsers should take in response to different commands. HTTP Authentication enables the requirement of usernames and passwords for device access.

	Table 8-1HTTP Settings
HTTP Settings	Description
State	Select to enable or disable the HTTP server:
	 Enabled (default)
	 Disabled
Port	Enter the port for the HTTP server to use. The default (80) will be restored
	when the field is cleared.
Inactivity Timeout	Enter the amount of time the HTTP server will hold power on after completing
	a request. This setting only applies if HTTP Server is enabled in
	Performance.
URI	Displays the root of the Uniform Resource Identifier (URI) to apply access
	control settings.
	Note: The URI must begin with ‘/’ to refer to the entire file system.
Auth Type	Select the authentication type:
	 None: no authentication is necessary.
	 Basic: encodes passwords using Base64.
Users	Displays the username allowed to access the configured URI.

To Configure HTTP Settings and Access Control

Using Web Manager

To configure HTTP settings, click HTTP in the menu and select Configuration.

Using CLI

To enter the HTTP Server command level: config -> HTTP Server

Using XML

Include in your file: <configgroup name = "HTTP Server">

Include in your file: <configgroup name = "HTTP Server Access Control" instance=”1”>

xPico® Wi-Fi® Embedded Device Server User Guide 46