Lantronix 900-691-R manual To Configure Tunnel Packing Mode Settings, Accept Mode

6: Tunnel Settings

To Configure Tunnel Packing Mode Settings

Using Web Manager

To configure the Packing mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Packing.

Using CLI

To enter the Tunnel command level: config -> Tunnel <instance>

Using XML

Include in your file: <configgroup name = "Tunnel Packing" instance = "1">

Accept Mode

In Accept mode, the xPico Wi-Fi listens (waits) for incoming connections from the network. A remote node on the network initiates the connection.

The configurable local port is the port the remote device connects to for this connection. There is no remote port or address. The default local port is 10001.

Serial data can still be received while waiting for a network connection, keeping in mind serial data buffer limitations.

	Table 6-3 Tunnel Accept Mode Settings
Tunnel Accept Mode		Description
Settings
Mode		Set the method used to start a tunnel in Accept mode. Choices are:
		 Disable = do not accept an incoming connection.
		 Always = accept an incoming connection (default).
		 Any Character = start waiting for an incoming connection when any
		character is read on the serial line.
		 Start Character = start waiting for an incoming connection when the
		start character for the selected tunnel is read on the serial line.
Local Port		Set the port number for use as the network local port. The default local port
		is 10001.
Protocol		Select the TCP type for use with Accept Mode.
Start Character		Enter the start character which will enable the tunnel to listen for a network
		connection. The start character may be designated as a single printable
		character or as a control character. Control characters may be input in any
		of the following forms:
		<control>J or 0xA (hexadecimal) or \10 (decimal)
		Note: This configuration option becomes available when Start Character
		is the selected Mode.

xPico® Wi-Fi® Embedded Device Server User Guide 36