Lantronix 900-691-R manual Modem Emulation Settings, To Configure Tunnel Disconnect Mode Settings

6: Tunnel Settings

To Configure Tunnel Disconnect Mode Settings

Using Web Manager

To configure the Disconnect Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Disconnect.

Using CLI

To enter the Tunnel command level: config -> Tunnel <instance>

Using XML

Include in your file: <configgroup name = "Tunnel Disconnect" instance = "1">

Statistics

Tunnel statistics contains data counters, error counters, connection time and connection information. Statistics are available at each individual connection and aggregated across all connections.

To View Tunnel Statistics

Using Web Manager

To view statistics for a specific tunnel, click Tunnel in the menu and select the Tunnel 1 -> Status.

Using CLI

To enter the Tunnel command level: status -> Tunnel <instance>

Using XML

Look for the status header: <statusgroup name = "line" instance = "1">

Modem Emulation Settings

Note: The following section describes the steps to view and configure Modem Emulation 1 settings; these steps also apply to Modem Emulation 2 settings.

	Table 6-6 Modem Emulation Settings
Modem Emulation	Description
Settings
Listen Port	Specify a listen port to accept connections.
Echo Pluses	Select to enable or disable echo pluses to be echoed back during “pause +++
	pause” escape sequence on the serial line.
Echo Commands	Select to enable or disable echo commands. If enabled, characters read on the
	serial line are echoed while the modem is in Modem Command Mode.

xPico® Wi-Fi® Embedded Device Server User Guide 40