Lantronix 900-691-R Tunnel Connect Mode Settings, Tunnel Connect Description Mode Settings

6: Tunnel Settings

Using XML

Include in your file: <configgroup name = "Tunnel Accept" instance = "1">

Connect Mode

Specifies the conditions for connecting any Accept Mode connection that may be established locally.

	Table 6-4 Tunnel Connect Mode Settings
Tunnel Connect	Description
Mode Settings
Mode	Select the method to start the Connect Tunnel:
	 Disabled: never started.
	 Always: always started
	 Any Character: started when any character is detected on the Serial Line
	 Start Character: started when the Start Character is detected on the Serial Line.
Local Port	View and if desired, override the default Local Value values.
	 Local port default values: Tunnel 1 is 10001 and Tunnel 2 is 10002.
	 Blank the display field to restore to default random setting.
Host <Number>	Lists exhisting hosts, if any for viewing and editing.
(Edit button)	 Click the Edit button beside a particular host to view the Address, Port and
	Protocol fields for this host.
	 Make any changes, as desired in the Address, Port and Protocol fields and click
	Submit to save.
	 Up to 2 hosts can be established. Additional hosts become available for editing/
	submitting as a host is edited.
Connections	Select the type of connection.
	 Sequential: connections for tunneling will begin from host 1 and proceed in
	sequence until a connection is accepted.
	 Simultaneous: all hosts accepting connetions will be connected.
Reconnect Time	Enter the reconnection time, which specifies how long the xPico Wi-Fi device server
	will wait in seconds before trying to reconnect to the remote host after a failed
	attempt or closed connetion. Blank the display field to restore the default.
Flush Line	Select to enable or disable the flush line at the time a connection is established with
	the network.
	 Enabled: buffered characters from the serial line will be discarded when a
	connection is established.
	 Disabled: any characters received on the serial line will be buffered and sent
	after a connection is established.
Block Line	Select to enable or disable the block line, which is used for debugging purposes.
	 Enabled: incoming characters from the serial line will not be forwarded to the
	network but will be buffered and will eventually flow off the serial line, if hardware
	or software flow control is configured.
	 Disabled: incoming characters from the serial line are sent to the network. Any
	buffered characters are sent first. This is the “normal” setting.

xPico® Wi-Fi® Embedded Device Server User Guide 38