|
| 6: Tunnel Settings |
|
|
|
| Modem Emulation | Description |
| Settings |
|
| Verbose Response | Select to enable or disable verbose response. If enabled, modem response codes |
|
| are sent out on the serial line. |
|
|
|
| Response Type | Select either Text or Numeric representation for the modem response codes sent |
|
| out on the serial line. |
|
|
|
| Error Unknown | Select to enable or disable error unknown commands. If enabled, ERROR is |
| Commands | returned to the serial line for unrecognized AT commands. |
|
|
|
| Incoming | Select Automatic, Manual or Disabled for the handling of incoming connections. |
| Connection |
|
|
|
|
| Connect String | Specify a customized string to be sent with the CONNECT modem response code |
|
| to the serial line, if any. |
|
|
|
| Display Remote IP | Select to enable or disable display remote IP. If enabled, the incoming ring sent on |
|
| the serial line is followed by the IP address of the caller. |
|
|
|
Using Web Manager
To configure the modem emulation for a specific tunnel, click Modem Emulation in the menu and select Modem Emulation 1
To view the modem emulation status for a specific tunnel, click Modem Emulation in the menu and select Modem Emulation 1
Using the CLI
To enter the Modem Emulation command level: config
Using XML
Include in your file: <configgroup name=”Modem Emulation” instance=”1”>
Table 6-7 Modem Emulation Commands and Descriptions
Command | Description |
AT? | Help. Displays this table. |
|
|
ATA | Answer incoming call request (if ATS0=2 or greater). |
|
|
ATD | Connects to the configured Connect Mode address and port. |
|
|
ATD | <address>:<port> Connects to the specified address and port. |
|
|
ATD 0 | Enters the Command Line Interface (CLI); exit returns to AT commands. |
|
|
ATDP | Same as ATD. |
|
|
ATDT | Same as ATD. |
|
|
ATEn | Switches echo in command mode (n=0: off, n=1: on). |
|
|
ATH | Disconnects the network session. |
|
|
ATI | Displays modem information. |
|
|
ATO | Switches to data mode if connection still exists. Reverse of '+++'. |
|
|
ATQn | Quiet mode (n=0: enable results code, n=1: disable results code.) |
|
|
ATS0=n | Accept connection. (n=0: no, n=1: auto, n=2+: via ATA command). |
|
|
xPico® | 41 |