Lantronix 900-558 manual Gap timer milliseconds, Line line

	5: Commands and Levels
	<string> = string that may contain binary characters.
	Within [] use binary decimal up to 255 or hex up to 0xFF.
command mode signon message <string>	Sets an ASCII sign-on message that is sent from the serial
	port when the
	device boots and when the line is in command mode.
	<string> = text.
command mode signon message binary <string>	Sets a binary sign-on message that is sent from the serial
	port when the
	device boots and when the line is in command mode.
	<string> = string that may contain binary characters.
	Within [] use binary decimal up to 255 or hex up to 0xFF.
command mode wait time <milliseconds>	Sets boot-up wait time for command mode serial string.
	<milliseconds> = wait time.
configure current settings	Configures line with the current value of settings.
data bits 7	Uses seven bits for data on the line.
data bits 8	Uses eight bits for data on the line.
default baud rate	Restores the default speed of 9600 bits per second.
default data bits	Restores the default of eight data bits.
default flow control	Restores the default of no flow control.
default interface	Restores the default interface type to this line.
default parity	Restores the default of no parity.
default protocol	Restores the default protocol on the line.
default stop bits	Restores the default of one stop bit.
default threshold	Restores the factory default threshold.
default xoff char	Restores the default xoff character on this line.
default xon char	Restores the default xon character on this line.
exit	Exits to the enable level
flow control hardware	Uses hardware (RTS/CTS) flow control on the line.
flow control none	Does not provide flow control on the line.
flow control software	Uses software (xon/xoff characters) flow control on the
	line.
gap timer <milliseconds>	Sets the gap timer in milliseconds. If some data has been
	received, it will
	be forwarded after this time since the last character.
interface rs232	Sets the line interface to RS232.
interface rs485 full-duplex	Sets the line interface to RS485 in full-duplex mode.
interface rs485 half-duplex	Sets the line interface to RS485 in half-duplex mode.
kill session	Kills command mode session on the Line
line <line>	Enters the line level.
	<line> = number of the line (serial port) to be configured.
lpd <line>	Enters the configure lpd level.
	<line> = number of the line (lpd serial port) to be confi-
	gured.
name <text>	Sets the name for this line.
no clear line counters	Restores the serial counters to the aggregate values.
no command mode	Disables command mode for the current line.
no command mode cp	Disables control of a CP to enter command mode.
no command mode serial string	Prevents the user-defined serial boot string from being
	used to enter
	command mode in the CLI.

XPort Pro Command Reference 102