| 5: Commands and Levels |
|
|
display remote ip enable | The incoming RING is followed by the IP address of the |
| caller. |
echo commands disable | Does not echo modem commands. |
echo commands enable | Echoes modem commands. |
echo pluses disable | Does not echo the +++ characters when entering modem |
| command mode. |
echo pluses enable | Echoes the +++ characters when entering modem com- |
| mand mode. |
error unknown commands disable | Returns OK on unknown AT commands. |
error unknown commands enable | Returns an error upon unknown AT commands. |
exit | Returns to the tunnel level. |
incoming connection automatic | Automatically answer incoming network connections. |
incoming connection disabled | Disable incoming network connections. |
incoming connection manual | Wait for an ATA command before answering an incoming |
| network connection. |
no connect string | Removes optional CONNECT string information for mod- |
| em emulation. |
reassert | Asserts tunnel modem status with current configured val- |
| ues. |
response type numeric | Uses numeric type responses. |
response type text | Uses text type responses. |
show | Displays the current configuration. |
show history | Displays the last 20 commands entered during the current |
| CLI session. |
show status | Displays tunnel modem status. |
verbose response disable | Does not send Modem Response Codes. |
verbose response enable | Sends Modem Response Codes out on the Serial Line. |
write | Stores the current configuration in permanent memory. |
packing |
|
clrscrn | Clears the screen. |
default packing mode | Sets to default packing mode, which is "Disable" |
default send character | Removes the send character for packing mode. |
default threshold | Restores the default threshold. |
default timeout | Restores the default packing mode timeout. |
exit | Returns to the tunnel level. |
no trailing character | Removes the trailing character for packing mode. |
packing mode disable | Disables packing. Data is sent to the network when re- |
| ceived. |
packing mode send character | Sets packing mode to accumulate data and transmit it |
| upon receiving the |
| configured send character on the line (serial port). |
packing mode timeout | Sets packing mode to accumulate data and transmit it |
| after a specified |
| amount of time (timeout). |
send character <control> | Sets the send character for packing mode. |
| The character may be input as text, control, decimal, or |
| hex. |
| A control character has the form <control>C. |
| A decimal value character has the form \99. |
| A hex value character has the form 0xFF. |
XPort Pro Command Reference | 107 |