Lantronix 900-558 manual Ip filter config-filter level commands, Line 1 line1 level commands

	5: Commands and Levels
clrscrn	Clears the screen.
default ip time to live	Restores the default IP time to live.
default multicast time to live	Restores the default IP multicast time to live, which is one
	hop.
exit	Exits to the configuration level.
ip time to live <hops>	Sets the IP time to live, known by SNMP as "ipDe-
	faultTTL".
	<hops> = number of hops that a typical IP packet is al-
	lowed to live.
multicast time to live <hops>	Sets the IP multicast time to live.
	<hops> = number of hops that a multicast IP packet is
	allowed to live.
no clear counters	Unzeros IP counters
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
show statistics	Shows IP statistics
write	Stores the current configuration in permanent memory.
ip filter (config-filter) level commands
add <ip address> <subnet mask>	Adds an entry to the IP filter table.
clrscrn	Clears the screen.
exit	Returns to the config level.
no filtering	Removes filtering so ALL addresses are allowed.
remove <ip address> <subnet mask>	Removes an entry from the IP filter table.
show	Displays the IP filter table.
show history	Displays the last 20 commands entered during the current
	CLI session.
write	Stores the current configuration in permanent memory.
line 1 (line:1) level commands
auto show statistics	Continuously displays line statistics.
baud rate <bits per second>	Sets the line speed.
	<bits per second> = the speed.
	Standard speeds include 1200, 2400, 4800, 9600, 19200,
	and so on.
clear line counters	Sets the serial counters to zero.
clrscrn	Clears the screen.
command mode always	Sets the current line to always be in command mode.
command mode cp	Sets the current line to enter command mode under con-
	trol of a CP.
command mode cp <cp group> <value>	Specifies the CP group and trigger value.
command mode echo serial string disable	Disables user-defined serial boot string to be echoed in
	the CLI.
command mode echo serial string enable	Enables user-defined serial boot string to be echoed in the
	CLI.
command mode serial string	Enables user to enter a custom string at boot time to enter
	command mode.
command mode serial string <string>	Sets a string that can be entered at boot time to enter
	command mode.
	<string> = text.
command mode serial string binary <string>	Sets a binary string that can be entered at boot time to
	enter command mode.

XPort Pro Command Reference 101