Lantronix 900-558 manual Test print number of lines, Modbus modbus level commands

	5: Commands and Levels
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
show statistics	Displays statistics and status information for this lpd line.
soj disable	Disables sending the start-of-job string after each print job.
soj enable	Enables sending the start-of-job string after each print job.
soj text binary <binary>	Sets the start-of-job text allowing for binary characters.
	<binary> = string in binary format that will be sent to the
	printer at the
	beginning of each print job.
	Within [] use binary decimal up to 255 or hex up to 0xFF.
soj text set <text>	Sets the start-of-job text.
	<text> = ascii string that will be sent to the printer at the
	beginning of
	each print job.
terminal <line>	Enters the configure-terminal level.
	<line> = number of the terminal line (serial port) to be con-
	figured.
terminal network	Enters the configure-terminal level for the network.
test print <number of lines>	Prints lines of text directly to the lpd line.
	<number of lines> = number of lines to print.
tunnel <line>	Enters the tunnel level.
	<line> = number of the tunnel line (serial port) to be confi-
	gured.
write	Stores the current configuration in permanent memory.
modbus (modbus) level commands
additional port <number>	Sets an additional TCP server port.
clrscrn	Clears the screen.
default response timeout	Restores the default Modbus Response Timeout.
exit	Exits to the config level.
kill connection <index>	Kills modbus connection selected by index from show
	connections.
no additional port	Removes the additional TCP server port.
response timeout <milliseconds>	Sets the Modbus Response Timeout in milliseconds.
rss	Enters the next lower level.
show	Displays the current configuration.
show connections	Displays connections.
show history	Displays the last 20 commands entered during the current
	CLI session.
show statistics	Displays statistics.
tcp server state disable	Disables the Modbus TCP Server.
tcp server state enable	Enables the Modbus TCP Server.
write	Stores the current configuration in permanent memory.
modem (tunnel-modem:1) level commands
clrscrn	Clears the screen.
connect string <text>	Sets the CONNECT string used in modem emulation.
	<string> = connect string.
default incoming connection	Default disables incoming network connections.
default response type	Default uses text type responses.
display remote ip disable	The incoming RING has nothing following it.

XPort Pro Command Reference 106