Lantronix 900-558 manual Traps config-snmp-traps level commands, Tunnel 1 tunnel1 level commands

	5: Commands and Levels
clear counters	Sets the TFTP counters to zero.
clrscrn	Clears the screen.
exit	Returns to the config level.
no clear counters	Restores the TFTP counters to the aggregate values.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
show statistics	Displays the TFTP statistics.
state disable	Disables the TFTP server.
state enable	Enables the TFTP server.
write	Stores the current configuration in permanent memory.
traps (config-snmp-traps) level commands
clrscrn	Clears the screen.
exit	Exits to the next higher level.
no primary destination	Deletes the primary SNMP trap host.
no secondary destination	Deletes the secondary SNMP trap host.
primary destination <text>	Sets the primary SNMP trap host.
	<text> = IP address of host running the SNMP trap.
secondary destination <text>	Sets the secondary SNMP trap host.
	<text> = IP address of host running the SNMP trap.
show	Shows the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
state disable	Disables the sending of SNMP trap messages.
state enable	Enables the sending of SNMP trap messages.
write	Stores the current configuration in permanent memory.
tunnel 1 (tunnel:1) level commands
accept	Enters the accept level for this tunnel.
auto show statistics	show connection statistics
clear counters	Zeros all tunnel counters
clrscrn	Clears the screen.
connect	Enters the connect level for this tunnel.
disconnect	Enters the disconnect level for this tunnel.
exit	Exits to the enable level.
line <line>	Enters the line level.
	<line> = number of the line (serial port) to be configured.
lpd <line>	Enters the configure lpd level.
	<line> = number of the line (lpd serial port) to be confi-
	gured.
modem	Enters the modem level for this tunnel.
no clear counters	Unzeros all tunnel counters
packing	Enters the packing level for this tunnel.
ppp <line>	Enters the serial line PPP level.
serial	Enters the serial level for this tunnel.
show history	Displays the last 20 commands entered during the current
	CLI session.
show statistics	show connection statistics
terminal <line>	Enters the configure-terminal level.

XPort Pro Command Reference 117