Lantronix 900-558 manual Host instance

	5: Commands and Levels
	connections to other devices.
default reconnect time	Restores the default reconnect time value for connect
	mode tunneling.
default start character	Defaults the connect mode start character.
email connect <number>	Sets an email profile to use to send an email alert upon
	establishing
	a connect mode tunnel.
	<number> = the number of the email profile to use.
email disconnect <number>	Sets an email profile to use to send an email alert upon
	closing
	a connect mode tunnel.
	<number> = the number of the email profile to use.
exit	Returns to the tunnel level.
flush serial disable	Characters already in the serial data buffer are retained
	upon establishing
	a connect mode tunneling connection.
flush serial enable	Flushes the serial data buffer upon establishing a connect
	mode tunneling
	connection.
flush start character disable	Enables forwarding of the connect start character into the
	network.
flush start character enable	Disables forwarding of the connect start character into the
	network.
host <instance>	Enters the next lower level.
	Specify the instance for the next lower level.
host mode sequential	Connects to the first host in the list that accepts the con-
	nection.
host mode simultaneous	Selects simultaneous connections to all hosts on the host
	list.
kill connection	Disconnects the active connect mode tunneling connection
	or connections.
local port <number>	Sets a specific port for use as the local port.
	<number> = the number of the port to use.
no email connect	Discontinues sending email alerts upon establishing a
	connect mode tunnel.
no email disconnect	Discontinues sending email alerts upon closing a connect
	mode tunnel.
promote host <number>	Promotes the identified host, exchanging it place with the
	host above it,
	to adjust the order of the defined hosts.
reconnect time <milliseconds>	Sets the reconnect time value for tunneling connections
	established by the
	device in milliseconds.
	<milliseconds> = timeout in milliseconds.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
show status	Displays tunnel connect status.
start character <control>	Sets the connect mode start character.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.

XPort Pro Command Reference 54