Lantronix 900-558 manual Lpd 1 config-lpd1 level commands, Line line

	5: Commands and Levels
	CLI session.
write	Stores the current configuration in permanent memory.
lpd 1 (config-lpd:1) level commands
banner disable	Disables printing banner for all print jobs. Only print the
	banner when a
	job requests it.
banner enable	Enables printing banner for all print jobs.
binary disable	Treats print job as ascii text. Filters out all non-ascii cha-
	racters and
	certain control characters.
binary enable	Treats print job as binary. Sends data byte-for-byte to the
	printer.
capture disable	Redirects serial output back to the line.
capture enable	Redirects serial output from the line to this CLI session.
clrscrn	Clears the screen.
convert newline disable	Disables converting single new line and carriage return
	characters to
	DOS-style line endings.
convert newline enable	Enables converting single new line and carriage return
	characters to
	DOS-style line endings. If characters are already in DOS
	line-ending order,
	they are not converted.
eoj disable	Disables sending the end-of-job string after each print job.
eoj enable	Enables sending the end-of-job string after each print job.
eoj text binary <binary>	Sets the end-of-job text allowing for binary characters.
	<binary> = string in binary format that will be sent to the
	printer at the
	end of each print job.
	Within [] use binary decimal up to 255 or hex up to 0xFF.
eoj text set <text>	Sets the end-of-job text.
	<text> = ascii string that will be sent to the printer at the
	end of each
	print job.
exit	Exits to the configuration level.
formfeed disable	Disables the printer from advancing to the next page at the
	end of each
	print job.
formfeed enable	Forces the printer to advance to the next page at the end
	of each print job.
kill	Ends the current print job on this lpd line.
line <line>	Enters the line level.
	<line> = number of the line (serial port) to be configured.
lpd <line>	Enters the configure lpd level.
	<line> = number of the line (lpd serial port) to be confi-
	gured.
no eoj text	Removes the end-of-job string.
no queue name	Removes the queue name.
no soj text	Removes the start-of-job string.
ppp <line>	Enters the serial line PPP level.
queue name <text>	Sets the name of the queue that this lpd line belongs to.
	<text> = name for the queue.

XPort Pro Command Reference 105