Lantronix 900-558 Password tunnel-accept-password1 level commands, Ppp 1 ppp1 level commands

	5: Commands and Levels
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
threshold <bytes>	Sets the threshold (byte count). If the queued data reach-
	es this threshold
	then the data will be sent.
	<bytes> = number of bytes in the threshold.
timeout <milliseconds>	Sets the timeout value for packing mode in milliseconds.
	<milliseconds> = timeout value, in milliseconds.
trailing character <control>	Sets the trailing character for packing mode.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
write	Stores the current configuration in permanent memory.
password (tunnel-accept-password:1) level commands
clrscrn	Clears the screen.
exit	Exits to the next higher level.
no password	Removes the password so connections will be accepted
	unchallenged.
password <text>	Sets the password required on the network side of the
	tunnel to begin
	a connection.
prompt disable	Inhibits any prompting for password on the network side of
	the tunnel.
prompt enable	Sets up so a user on the network side of the tunnel will be
	prompted for
	a password.
show	Shows the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
write	Stores the current configuration in permanent memory.
ppp 1 (ppp:1) level commands
authentication mode chap	Sets authentication to Challenge-Handshake Authentica-
	tion Protocol (CHAP).
authentication mode ms-chap	Sets authentication to MS-CHAP version 1.
authentication mode ms-chapv2	Sets authentication to MS-CHAP version 2.
authentication mode none	Removes PPP authentication.
authentication mode pap	Sets authentication to Password Authentication Protocol
	(PAP).
clrscrn	Clears the screen.
default authentication mode	Removes PPP authentication.
exit	Exits to the configuration level.
line <line>	Enters the line level.
	<line> = number of the line (serial port) to be configured.
local ip <ip address/cidr>	Sets the Local IP address and network mask.
	Formats accepted:
	192.168.1.1 (default mask)
	192.168.1.1/24 (CIDR)
	"192.168.1.1 255.255.255.0" (explicit mask)
lpd <line>	Enters the configure lpd level.

XPort Pro Command Reference 108