Lantronix 900-558 manual XPort Pro Command Reference 103

	5: Commands and Levels
no command mode signon message	Clears the signon message displayed at boot time and
	when entering
	command mode.
no gap timer	Removes the gap timer, so forwarding depends on the line
	speed.
no name	Removes the name of this line.
parity even	Uses a parity bit on the line for even parity.
parity none	Does not use a parity bit on the line.
parity odd	Uses a parity bit on the line for odd parity.
ppp <line>	Enters the serial line PPP level.
protocol lpd	Applies Line Printer Daemon (LPD) protocol on the line.
protocol lpd or tunnel	Applies LPD or tunnel protocol on the line.
protocol modbus ascii	Applies Modbus ASCII protocol on the line.
protocol modbus rtu	Applies Modbus RTU protocol on the line.
protocol none	Uses no protocol on the line.
protocol ppp	Applies point-to-point protocol (PPP) on the line.
protocol tunnel	Applies tunnel protocol on the line.
reassert	Asserts line status with current configured values.
show	Displays the current status.
show command mode	Shows the command mode settings for the current line.
show history	Displays the last 20 commands entered during the current
	CLI session.
show line	Displays the current configuration.
show statistics	Shows the line statistics.
state disable	Disables the line so data cannot be sent/received.
state enable	Enables the line so data can be sent/received.
stop bits 1	Uses one stop bit after data on the line.
stop bits 2	Uses two stop bits after data on the line.
terminal <line>	Enters the configure-terminal level.
	<line> = number of the terminal line (serial port) to be con-
	figured.
terminal network	Enters the configure-terminal level for the network.
threshold <bytes>	Sets the threshold in bytes. After this many bytes are re-
	ceived, they are
	forwarded without delay.
tunnel <line>	Enters the tunnel level.
	<line> = number of the tunnel line (serial port) to be confi-
	gured.
write	Stores the current configuration in permanent memory.
xoff char <control>	Sets the xoff character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
xon char <control>	Sets the xon character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.

XPort Pro Command Reference 103