Using the Meter • 3
Printing Postage
Using the Default
Value
The default postage value is set at the factory or by you while the meter is in the setup mode. (This value is often that for first class mail weighing up to one ounce). This value ap- pears in the display after you turn the meter on and the self test is completed. The default value also displays automati- cally after the meter has been inactive for a period of time.
The meter is ready to use when the default value is shown bracketed by three bars. See the figure at right.
1.Select the account to which you want to charge postage (B700 only, if your B700 is equipped with the optional ac- counting feature).
2.(B700 only) Select the advertising slogan and/or the in- scription you want to use .
3.To print postage using the default value, place your ma- terial (envelope, post card or tape sheet) on the transport face up and push it against the rear wall (1). Slide it to the right up to the trip mark (2) and let go as the meter takes the mailpiece. See the figures below.
| 2 |
| 1 |
SV60941 Rev. B |