Ultra electronic ID Card Printer manual Ink mode setting

Operation (continued)

Ink mode setting

Change settings according to the ink ribbon used.

> I n k >

ENTER

EXIT

Exit user mode

> > I n k T y p e		Set ink ribbon
		Set ink type (YMCK:0, YMCK+HS:1)
	Y M C K : 0	 Yellow (Y), Magenta (M), Cyan (C) and Black (B) are
		provided as the standard ink ribbons. Change the setting to
EXIT	MENU	YMCK+HS when using a special panel ink ribbon (not yet
		available).
		to select the	ENTER
	Press	setting and	to save.
		press	(The electronic
			beep sounds .)

Set the black value K

> > B l a c k L e v e l 7 gradations can be set

(from –3 to +3, the larger the value the darker the printing)

	0 ( S t a n d a r d )
		 Small characters printed in black ink may be blurred or
		partially darkened. If this is the case, change the setting.
EXIT	MENU
		to select the setting	ENTER
	Press		to save.
		value and press
			(The electronic
			beep sounds .)

> > B l a c k M o d e	Set the K printing mode:
	2 options (Standard and Fine)

S t a n d a r d

Specify +gFine+h if blurring still occurs after an increase in +gBlack Level.+h The printing time slightly becomes longer in this setting.

EXIT MENU

	to select the	ENTER
Press	setting value	to save.
	and press	(The electronic
		beep sounds .)

			Special ink SP-Ink 1, SP-Ink 2 darkness level.
> > S P - I n k	1 L e v e l		7 gradations can be set
o r		- 2	(from –3 to +3, the higher the value the darker the printing.)
> > S P - I n k 2 L e v e l
	- 2		 Set this darkness level when using a special ink (not yet
			available).
EXIT	MENU	Press		ENTER
			to select the setting
				to save.
			value and press (The electronic beep sounds .)

30