Setting the retransfer film
CAUTION
Do not touch the retransfer film surface with your hands.
1. Activate the slide knob and open the printer door.
3. Insert the retransfer film into the cassette.
Stretch the retransfer film along three shafts with the retransfer face of the film facing outside and insert the bobbins into the bobbin holders firmly.
At this time, perform setting so that the film is inside the guide. Make sure to wind the film on to the wind spool for more than two frames.
When the slide knob is moved, the door opens downwards. Hold the door with your hand and open it slowly.
Retransfer film cassette (green)
CAUTION
Shaft
Guide 
Retransfer face (do not touch the surface)
Bobbin holder (green)
Feed spool (green bobbin)
Wind spool (black bobbin)
Wind the film by about two frames on the winding bobbin.
One frame
Do not put the ink ribbon or retransfer film on the back of the door for mounting. Do not rest your elbows or put any heavy object on the back of the door as it may break.
2. Remove the retransfer film cassette.
When you press the lever, a small portion of the cassette pops out.
Press the cassette removal lever.
Bobbin holder (black)
Place the cassette upright on a flat surface during set-up.
CAUTION
When you need to take out the cassette, for instance, to clean the printer, be sure to put it upright as shown in the above illustration. When the film is put on the table with its retransfer face down, dusts attach to the surface, causing a failure of the printer.
16