Be sure NOT to do any of the following during printing operations:
Do not open the printer door.
Do not open the card tray.
(while the LCD panel displays ‘Loading’)
Do not turn off the power supply.
Do not unplug the unit.
Do not pull out the connection cable.
Failure to observe the above points will cause printing to be aborted and may result in a malfunction of the unit.
CAUTION
When the printer was occured an error during printing operation caused by above- mentioned operation or others, the retransfer film was rewinded about 3 panels. If the printer is turned off and on the power or is initialized, the printer occur the printing an error which is “INK RUNOUT” or print results problem because of the printer try to print the used retransfer film. Wind up the retransfer film about 3 panels by unused panel. See p.18 “Caution when loading the retransfer film cassette and/or the ink ribbon cassette” and p.25 “On initialization when the retransfer film casstte and/or the ink ribbon cassette is loaded”.
Turning off the power
1. Check the printer status.
In ready, preheat or error status, check that printer operations are suspended.
2. Turn off the printer’s power.
Always wait 10 seconds or more before turning the power back on again.
About the RESET button
When an error occurs in the printer, press the RESET button, then the ENTER button.
The printer is initialized with this operation.
If the error still persists, see p.41 and take the
appropriate actions.
Then, press the RESET button, and the ENTER button again. The printer is initialized, and returns to the “Ready” state.
(When you turn off the power, these procedures are not necessary.)
On Initialization when the retransfer film cassette and/or the ink ribbon cassette is loaded
Dust or foreign particles may attach on the surface of retranfer film and ink ribbon when their cassette are removed from the printer.
This may cause defective printing such as image void, defective retransfer etc.
To Avoid this, it is recommended that the retransfer film and the ink ribbon are wound up one or two panels after they are reloaded.
Please follow the initialization procedure described below:
1. Turn the power switch on, and wait until the LCD indicate or displays “Preheat” or “Ready”.
2. Depress the RESET key.
LCD indicator displays:
| I n i t i a l i z e |
|
|
|
|
|
|
|
| O K ? |
|
|
|
|
|
|
|
|
|
|
3. By depressing the |
| key or the |
| key, | ||
|
| |||||
the LCD indicator change accordingly as shown below.
Select the
I n i t i a l i z e
2 ' n d P a n e l , O K ?
Initialized after two panels of the retransfer film and the ink ribbon are would up.
I n i t i a l i z e
N E X T P a n e l , O K ?
Initialized after one panels of the retransfer film and the ink ribbon are would up.
I n i t i a l i z e
O K ?
Initialized without winding up. (Default)
4.By depressing the ENTER key, the printer is
initialized according to the selected above set up condition.
25