Tannoy ACTIVE STUDIO MONITORS owner manual System Setup Configuration, Analog Gain, BNC Sync

Page 38

A C T I V E S T U D I O M O N I T O R S

iDP SOFT™ (cont.)

During Software upload various messages could be displayed:

Example:

“Precision monitor updated successfully” means the Precision monitor has been updated successfully.

Precision iDP™ monitor updated successfully

If the message: “Failed to update Precision iDP™ monitors” – means the monitor has reported an error during software upload. This could be caused by communication errors. Please retry.

<OK>

Press to exit screen and execute AutoDetect command if marked.

System Setup

<Configuration>

Select your current setup.

<Analog Gain>

Range: +9dBu, +15dBu, +21dBu or +27dBu

Set to match analog Input gain to match the signal fed to the optional Analog Input card.

<BNC Sync>

BNC Sync On:

The monitor attempts to lock on the word clock BNC.

38

Image 38

Contents Owners M a N U a L Page Important Safety Instructions Important Safety Instructions Quick Setup Guide T I V E S T U D I O M O N I T O R S Introduction Concept & Design Philosophy Tannoy Dual ConcentricTannoy WideBand SuperTweeter High efficiency compact Switched Mode Power Supply SmpsUnpacking & Visual Checks Orientation Speaker PlacementPreliminary Recommendation Master & Slave Concept Initializing the Network Remote ControlSlave Monitor & Subwoofer IDP Soft Software RemoteMaster Unit Slave/SubwooferSUB General Setup Procedure IDP Display MasterAnalog Stereo Set-up With Mono Subs SetupsGeneral Setup Procedure Analog Stereo Set-up With Stereo Subs Stereo Digital Set-up With Mono SubsAnalog Set-up Digital Set-upDigital 192kHz Set-up Digital Set-up Analog Set-up Alternative 7.1 Set-up Analog, Digital& 192kHzConnecting Two Subs Connecting Three SubsDig/6 Master Stereo Set-up With Chains on L&R. Analog or DigitalSetup when the monitors are connected Select Setup Reset ProcedureReset All Settings Select Monitor TasksMain Display Press Enter to access the Select ModeParameter Description † PC-iPLFE Low Pass Filter PhaseBass Management LFE GainSet Monitor Task Setup MenuSetup External ClockParameters available for the subwoofer LFE channel importantParameter Categories IDP Remote REF Level keys Preset 1/3 and 2/4 keysVolume potentiometer MUTE/UNMUTE Solo keys for the channels R LS- SUB RSIDP Soft Installation on PCInstallation on Mac Minimum requirementsMonitor and Sub icons Volume ControlREF LEV. keys Bass Mgt Bass ManagementStore presets IDP Soft Preset ListRecall presets Locked symbol in Preset ListIDP Soft Network Upload Software to MonitorsBNC Sync System Setup ConfigurationAnalog Gain Monitor Assignment Calibrate Main MonitorsCalibrate Subwoofer LFE Low Pass Filter Phase RangeLFE Gain Range 0 to 14dB Chained monitors Technical Specifications Precision 6 iDP System Master & SlavesTechnical Specifications- Precision 8 iDP Technical Specifications TS212 iDP Subwoofer TS112 iDP Subwoofer & iDPDimensions Precision 6 iDP Dimensions Precision 8 iDP Dimensions Precision TS212 iDP Grey/Silver Dimensions Precision TS112 iDP GreyIDP Display Messages System Delays Sample Rate Digital Input Analog Input Curves ExplainedSUB LFE AES/EBU Standard cables CablesTC Link Standard Cat-5 cables Serial to Cat-5 cableDeclaration Of Conformity Warranty Page Issue Software Version 1.53 Part No GH 01 December