Configure the settings relating to SNMP [SNMP]
Click the [SNMP] tab on the "Network setup" page. (☞ page 50)
The settings relating to SNMP can be configured on this page. It is possible to check the status of the unit by con- necting to the SNMP manager. When using the SNMP function, contact the network administrator.
[Community name]
Enter the community name to be monitored. Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
Important:
When using the SNMP function, it is necessary to enter the community name. When no community name is entered, the SNMP function will not work.
[Unit title]
Enter a unit title to be used to manage the unit with the SNMP function.
Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
[Unit location]
Enter the name of the location where the unit is installed.
Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
[Contact (Destination address or phone number of manager)]
Enter the mail address or the phone number of the SNMP manager.
Number of characters that can be entered: 0 - 255
characters
Default setting: (blank)
Notes:
•"" is regarded as a blank.
•It may take around 30 seconds until the setting is applied.
54