Initialize/restart the unit [Initialization]
Click the [Initialization] tab of the "Maintenance" page. (☞ page 57)
Initialization of the setup data and HTML files of the unit and restarting of the unit can be performed on this page.
[Initialize setup data (Except network setup data)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset. It is impossible to operate the unit for around 3 minute after the initialization.
[Initialize HTML data]
Click the [Execute] button to reset the HTML files to the default. It is impossible to operate the unit for around 3 minute after the initialization.
[Initialize setup data and HTML data]
Click the [Execute] button to reset the settings of the unit and the HTML files to the default. Note that the net- work settings will not be reset. It is impossible to oper- ate the unit for around 3 minute after the initialization.
[Video analytics setup data]
Click the [Execute] button to reset the video analytics setup data to the default.
[Camera restart]
Click the [Execute] button to restart all the cameras con- nected to the unit.
After restart, it is impossible to control the cameras for around 1 minute.
[Unit restart]
Click the [Execute] button to restart the unit. The unit will be inoperable for around 3 minutes after the restart just as when the power is turned on.
Notes:
•To initialize all the settings, do the following. Turn off the power of the unit. Turn on the power of the unit by setting the Dip Switch 1 on the front of this unit to ON, and wait around 90 seconds. The unit will start up and all the settings including the network settings (☞ page 50) will be initialized.
When initializing the network settings (except the HTTP port number setting) only, set the Dip Switch 2 to ON. After initialization, be sure to set the Dip Switch 2 to OFF, and turn on the power of the unit again. (Refer to the provided operating instructions for further information about the dip switch.)
•When the notification function is on, notification will be provided to the registered addresses (mail address or IP address) when the SD memory card has failed to mount after the restart or when the inserted SD memory card is locked. (☞ page 45)
59