Toshiba E6581830 instruction manual Trip history

Page 21

E658130

5.5.5. Trip history

When “Quadruple setting” or “Octuple setting” of CC-LINK V.2 is selected, the past trip information can be referred to by the following methods.

		Upper 8	Trip history No.		Upper 8	Trip history No..
		Bits	Trip history No.		Bits	Trip history No..
	RWr n+8	Bits		RWw n+8	Bits
	RWr n+8	Lower 8	Trip code	RWw n+8	Lower 8	Reserved
		Lower 8			Lower 8
		Bits			Bits
		Bits			Bits
	RWr n+9	Trip information (output frequency)		RWw n+9	Reserved
	RWr n+A	Trip information (output current)		RWw n+A	Reserved
	RWr n+B	Trip information (output voltage)		RWw n+B	Reserved
	RWr n+C	Trip information (energization time)		RWw n+C	Reserved

1.Set the past trip history No. to upper 8 bits of "RWw n+8."

2.The following information is stored to registers.

Trip history No. : Upper 8 bits of "RWr n+8."

Trip code	: Lower 8 bits of "RWr n+8."
Output frequency : “RWr n+9”
Output current	: “RWr n+A”
Output voltage	: “RWr n+B”

Energization time : “RWr n+C”

- 20 -

Image 21

Contents CCL003Z Introduction Handling in general Table of Contents Overview Basic specificationsCC-Link Ver CC-Link VersionNames and functions OutlineSLD Installation on inverter Connection cableTerminating resistor DA,DB Connection of CC-Link master unit and inverterMaximum connection number of units Page LED indicator RUN ERRRUN Functions Initial settingC101 Communication parameters for CCL003ZBaud rate setting CC-Link function setting Station number settingCC-Link extended setting Basic functions Run and frequency operation commandMonitor Writing and reading the parameterRAM I/O signal list One station is occupied CC-Link Ver.1 c122=0Quadruple setting is selected CC-Link Ver.2 c122=2 Double setting is selected CC-Link Ver.2 c122=1Octuple setting is selected CC-Link Ver.2 c122=3 Trip history RYnF Instruction code execution request Detail of input and output signals120 On ST = OFF OFF ST = onRemote Register Assignment Instruction code 3 It is the same as instruction code 1 Monitor code RWwn is set Signal Description 00EDH Instruction Codes00FCH 00FDHEx A900 A900H, C123 C123H Details of an error code Fault record display example Reply code Description of reply codeDescription of monitor code Description of output terminal information Description of input terminal informationProgramming examples SW0 SB0RWr0 Program example for reading the inverter status X0FEND Program example for setting the operation mode Program example for setting the running frequency Program example for setting the operation commandsPLS SETProgram example for monitoring the output frequency Program example for parameter writing Program example for parameter reading MOV Program example for trip information readingProgram example for resetting the inverter at inverter error Instructions Option error Disconnection error of network cableUnusual diagnosis CPU How to check the error using the LEDsTime Line ERR RUN CCL003ZTime Line RUNERR Line RUN Time RUNERR Time RUN Time ERR